Status Read Commands
LW600-LX900-LX1000 RS232 Codes-Expanded Technical Reference Information 8-11
020-000046-02 Rev 2 (07-2011)
8.5.6 CF_DDOTS Command
Command
“CF_DDOTS_%1” [CR]
%1
“0256-nnnn” - Directly specify setting value of Display Dots
“nnnn” indicates maximum value, which is current value of (Total
Dots - Position H). H). In this projector, the value should be“even
number” and if “odd number” is specified, it adds 1 to make the
value even number.
“UP” - Increment setting value of Display Dots by 2
“DN” - Decrement setting value of Display Dots by 2
Detail
Set Display Dots value in PC signal (available only in the normal
Power ON status).
The value set by this command is not stored in the projector’s
memory. Therefore, when the power is turned to ALL OFF status, the
value returns to the original setting. (It is stored in Suspend mode.)
Response Acceptable
“000” [CR]
Unacceptable
“101” [CR]
• When input is Video signal
• When input is no signal
8.5.7 CF_DLINE Command
Command
“CF_DLINE_%1” [CR]
%1
“0100-nnnn” - Directly specify setting value of Display Line
“nnnn” indicates maximum value, which is current value of (Total
Line - Position V).
“UP” - Increment setting value of Display Line by 1
“DN” - Decrement setting value of Display line by 1
Detail
Set setting value of Display Line in PC signal (available only in the
normal Power ON status).
The value set by this command is not being stored in the projector’s
memory. Therefore, when the power is turned to ALL OFF status, the
value returns to the original setting. (It is stored in Suspend mode.)
Response Acceptable
“000” [CR]
Unacceptable
“101” [CR]
• When input is Video signal
• When input is no signal
Comments to this Manuals